Routine Maintenance; Clean The Mopping Module - Dreame Bot Z10 Pro Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50

Routine Maintenance

EN
Clean the Dust Bin
1. Open the robot cover, then press the dust
2. Open the bin cover and empty the
bin clip to remove the dust bin.
bin as shown in the diagram.
4. Clean the dust intake.
5. Rinse the dust bin and filter with water until they are clean. Thoroughly dry the filter before re-
installing.
Note:
• Rinse the filter with clean water only.Do not use detergent.
• Before using, keep it in a well-ventilated or cool place.
14
3. Remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a
brush or finger.
Routine Maintenance

Clean the Mopping Module

1. Press the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with only water and leave out to air
dry before re-installing.
Note: Do not expose the tank to the sun directly.
3. Clean the mop pad with water only and leave to air dry before re-installing.
Note:
• Remove the pad from the mopping module before cleaning it, and make sure
dirty water does not flow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every 3-6
months.
4. If slow water flow occurs, or the volume is not well-distributed, clean the air
hole in the cover of the water tank.
EN
15

Publicidad

Tabla de contenido
loading

Tabla de contenido