Introduction; Installation; General - Vetus ILTCOND Instrucciones De Instalación Y Manual Del Propietario

1

Introduction

This manual applies to the connection kit ILT-
COND and for the Vetus (fixed) plastic tanks
type ATANK (42 to 390 liters) and type APT100
(100 liters) when used as a water tank.
2

Installation

2 1

General

When choosing a location for the tank and a
place for the deck filler cap, take the following
into account:
The filler hose must be kept as short as possi-
ble, it must run continuously to the tank and be
as straight as possible.
Positioning
Install the tank in such a way that it is easily ac-
cessible for inspection. The tank should always
be installed above the maximum bilge water
level.
Also ensure that there is sufficient free space
at the top of the tank for the hose connection.
This connection must be easily reached during
installation. For ventilation, the tank should
have a free space of about 1 cm (3/8"). from
bulkheads or other tanks.
Make sure the tank has a sufficiently secure
foundation on which to install it and secure it
properly.
The dimensions of the tank will increase a
little when it is filled. Take this into account
when fixing the tank.
vetus® Connection kit for drinking water tanks
See the drawings on page 54-55 for dimen-
sions. Tolerances of + or - 2% apply to all dimen-
sions!
Position the tank (ATANK) in such a way
that the plug P is on the top side of the
tank. Consult the diagrams on page 54-55
for placement of plug P.
70 mm
70 mm
ENGLISH
N
ote
± 30 mm
11
050106.01