Care And Maintenance - Hilti BX 3-BT Manual De Instrucciones Original

6.3 Driving a fastener
WARNING
Risk of injury by flying parts! When fasteners are being driven, there is a risk of injury to the body and eyes
caused by material splintering off the working surface and also if there are foreign bodies in the area of the
fastener guide.
▶ Wear personal protective equipment and always wear protective glasses and protective gloves.
Other persons in the vicinity must also wear eye protection and a hard hat.
▶ Never attempt to remedy tool malfunctions by continuing to trigger the tool.
WARNING
Risk of injury! Pressing the nosepiece of the fastening tool against a part of the body may lead to serious
injury due to inadvertent firing and release of a fastener.
▶ Never press the nosepiece of the tool against your hand or any other part of the body.
CAUTION
Risk of injury and risk of damage to the fastening tool. The use of unsuitable material and accessories
can lead to injuries and damage the fastening tool.
▶ Use only approved, genuine Hilti accessories with this tool.
1. Switch on the fastening tool. → page 20
2. Insert the threaded stud.
3. Hold the fastening tool perpendicular to the working surface, center the fastener guide, loaded with a
suitable threaded stud, over the pre-drilled hole and apply pressure to seat the fastener guide against
the working surface.
4. Drive the fastener by pulling the trigger.
5. Lift the fastening tool completely clear of the working surface after driving a fastener.
The fastening tool switches itself off automatically if the fastener guide is pressed against the
working surface for longer than 6 seconds without a fastener being driven. The fastening tool can
be switched on again by pressing the on/off button.
The fastening tool switches itself off automatically if it is not used for 6 minutes.
6.4 Switching off Bluetooth
▶ Press the on/off button for at least 5 seconds until the LED shows blue twice.
➥ No further data transfer is possible.
➥ Bluetooth is not available in all markets
Bluetooth can be deactivated if you are in a sensitive environment (e.g. a hospital) where use of
Bluetooth is prohibited.
7

Care and maintenance

7.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Switch off the fastening tool.
• Remove the battery.
• Remove the fastener from the fastener guide.
• Carefully remove any dirt that may be adhering to parts.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these can attack the plastic parts.
*2209576*
Printed: 20.09.2019 | Doc-Nr: PUB / 5514238 / 000 / 00
5
2209576 English 21