Troubleshooting; Corrective Action; Warranty - Kobalt KMT 124B-03 Manual Del Usario

TROUBLESHOOTING

WARNING
• Set the On/Off switch (E) to the OFF position and detach the battery pack from the multi-tool before
performing troubleshooting procedures.
PROBLEM
The multi-tool does not work.
Strong vibration or loud noise
during operation.
Motor overheating.
The LED worklight blinks
rapidly
The LED worklight blinks
slowly.

WARRANTY

For 5 years from the date of purchase, the power tool is warranted and for 3 years from date of
purchase the battery & charger are warranted for the original purchaser to be free from defects
in material and workmanship. This guarantee does not cover damage due to abuse, normal
wear, improper maintenance, neglect, unauthorized repair/alteration, or expendable parts and
accessories expected to become unusable after a reasonable period of use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at no
charge. This guarantee gives you specific legal rights, and you may also have other rights that
vary from state to state.
POSSIBLE CAUSE
Battery pack is depleted.
Accessory is not installed
securely.
Cooling vents are obstructed.
The tool has stopped working
to protect internal circuits.
The battery charge is very low. Charge the battery.
16

CORRECTIVE ACTION

Charge the battery pack.
Reinstall the accessory
according to "Installing and
Removing Accessories"
Clean and clear vents. Do not
cover vents with hand during
operation.
Turn the tool OFF, wait for the
tool to cool down, then start
the tool again.
Printed in China
KOBALT® and the K Design® are registered
trademarks of LF, LLC. All Rights Reserved.
kobalttools.com