Operating Instructions - Kobalt KMT 124B-03 Manual Del Usario

OPERATING INSTRUCTIONS

1. To Attach Battery Pack
a. Place the On/Off switch (E) in the OFF position.
b. Align the raised portion on the battery pack with the
grooves on the bottom of the tool and then slide the
battery pack onto the tool as shown.
c. Make sure that the latches on the battery pack snap
into place and the battery pack is secured to the tool
before beginning operation.
NOTICE: When placing the battery pack on the tool,
be sure that the raised rib on battery pack aligns with
the groove on the tool and the latches snap into place
properly. Improper attachment of the battery pack can
cause damage to internal components.
To Detach Battery Pack
a. Place the On/Off switch (E) in the OFF position.
b. Press the battery-release buttons to release the
battery pack.
c. Pull forward on the battery pack to remove it from
the tool.
WARNING
• Battery tools are always in operating condition.
Therefore, the On/Off switch should always in the OFF
position when the tool is not in use or when carrying
the tool at your side.
2. On/Off Switch
a. To turn the multi-tool ON, push the On/Off
switch (E) forward.
b. To turn it OFF, move the On/Off switch toward
the rear.
1a
E
1b
E
2
8
E
kobalttools.com