Kohler K-1954 Guía De Instalación Y Cuidado página 17

Troubleshooting
NOTICE: Risk of property damage. If the toilet is plugged, turn off
the water supply before attempting to unplug it. The sensor can be
inadvertently activated while unplugging the toilet, resulting in an
overflow.
NOTE: For service parts information, visit your product page at
www.kohler.com/serviceparts.
Symptoms
1. The toilet is blocked.
2. Nothing happens when I
try to activate the sensor.
3. The module works, I hear a
beep, the wheel rotates, the
chain moves, but the toilet
does not flush.
4. The wheel contacts the
flush valve when flushing.
5. The toilet flushes, but the
flush is weak.
6. The sensor is not sensitive
enough (does not activate
when hand is within 1" (25
mm) - 2" (51 mm)).
7. The toilet flushes when I
am sitting on it.
Kohler Co.
Recommended Action
A. Turn off the water supply. Clear
the blockage using a plunger.
Consult the toilet troubleshooting
guide for further information.
A. Confirm the batteries are correctly
installed.
B. Confirm the batteries have a
charge.
A. Remove some of the slack from
the chain.
B. Confirm the chain is attached to
the wheel and flush valve.
A. Relocate the module further from
the flush valve to allow room for
operation.
A. Remove any slack in the chain.
A. Move the module up one notch on
the bracket if the gap is more than
1/4" (6 mm).
B. Confirm the sensor emblem is
located directly above the icon on
the module. Relocate the emblem
if it is not located correctly.
A. Are you leaning back and
bumping the tank lid? Moving the
tank lid may cause the toilet to
flush.
B. Are pads installed on the tank
rim? Install the provided foam
pads on the tank rim to stabilize
the tank lid.
17 1216369-2-D