Required Accessories - LG WKEX200HA Serie Manual De Instalación

22 INSTALLATION
NOTE
• Periodically check the hoses for cracks, leaks,
and wear, and replace the hoses every five years.
• Do not stretch the water hoses intentionally, and
make sure that they are not pinched, crushed or
kinked by other objects.
• Water supply pressure must be between 20 psi
and 120 psi (138 - 827 kPa). If the water supply
pressure is more than 120 psi, a pressure
reducing valve must be installed.
• Your hot water heater should be set to deliver
water at 120–135 ℉ (48–57 ℃) to allow the
appliance to properly control wash
temperatures.
• Do not store or install the appliance in a location
subject to freezing temperatures. Damage to the
water inlet hoses and internal mechanisms of
the appliance can result. If the appliance was
exposed to freezing temperatures prior to
installation, allow it to stand at room
temperature for several hours before use and
check for leaks prior to operation.
• Do not use flood-preventing hoses with auto
shut off devices. The devices can be tripped
during fill and prevent the appliance from filling
properly.

Required Accessories

Hot and Cold Water Hoses (for Washer)
a
Cold Water Hose (for Dryer)
b
Connecting Supply Hose
c
Tie Straps
d
1
Check the fittings and seals. Inspect the
threaded fitting on each hose and make sure
there is a rubber seal
of each hose to prevent leaking.
2
Connect the Y connector
. Connect the 2 blue hoses
g
connector.
in place in both ends
e
to the short hose
f
to the Y
h
3
Connect the water supply hoses.
• Connect the water inlet hoses to the hot
and cold water faucets tightly by hand and
then tighten another 2/3 turn with pliers.
• Connect the short blue hose to the cold
water faucet and the red hose to the hot
water faucet.
4
Flush out the inlet hoses.
• After the hoses are connected, turn on the
water faucets and flush out any foreign
substances such as dirt, sand, or sawdust.
• Let the water drain into a bucket, and check
the water temperature to make sure you've
connected the hoses to the correct faucets.
5
Attach the inlet hoses to the back of the
appliance and secure the cold water inlet
hoses with tie straps
For the Washer
• Attach the hot water inlet hose
water inlet on the back of the washer.
Attach the cold water inlet hose
cold water inlet on the back of the washer.
For the Dryer
• Attach the cold water inlet hose
cold water inlet on the back of the dryer.
.
k
to the hot
i
to the
j
to the
j