Hanging The Fan - Progress Lighting AirPro P250067 Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Hanging the Fan

REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1.Route the wires exiting the top of the
fan motor through the cover (D) and then
through the canopy (C) , downrod (B) and
hanger ball (J) assembly.(Fig.5)
Figure 5
Step 2. Insert the downrod (B) through the
metal cover (D) and canopy (C). (Fig 6)
Step 3. Insert the end of downrod (B) through
the connector (PP),align the two holes in the
downrod (B) and the connector (PP).(Fig.6)
Step 4. Insert a plug pin (GG) through the two
holes in the downrod (B) and the connector
(PP). (Fig.6)
Step 5. Insert the R-shaped pin (HH) though
the hole near the end of the plug pin (GG) until
it snaps into its locked position. (Fig.6)
Step 6. Install the screw (FF) to the connector
(PP), and make sure it's tighten, Screws (FF)
should be tight against the downrod (B). (Fig.6)
Step 7. Insert the hanger ball (J) onto the
downrod (B), and then insert a plug pin (L)
through the hole in the downrod (B). (Fig.7)
Step 8. Insert the plug pin to the slot cut off in
the hanger ball (J) until it snaps into its locked
position. (Fig.6)
Step 9. Use the Screw(K) to lock the hanger
ball (J) to the downrod (B). (Fig.7)
Step 10. Install the Hanger bracket (A) on the
outlet box by using the washer (BB) and
screws(AA) provided with the
(Fig.8)
Step 11. Put the hanger ball (J) through the
open side of the ceiling mounting bracket (A),
and then insert the hanger ball(J) to the slot cut
off in the ceiling mounting bracket(A). (Fig.8)
Figure 6
Figure 8
Figure 7
box.
Outlet
4.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Airpro p250067-143-wb

Tabla de contenido