Getting Started
Temperature Probe
Temperature Probe
Use only the temperature probe shipped with this
appliance. The temperature probe measures the internal
temperature of food while cooking. The probe can be
used to monitor the temperature without setting a
desired temperature and can be used with all cooking
modes except Broil, Proof, and Dehydrate.
CAUTION
The probe and probe receptacle will be very hot.
Handle with care.
CAUTION
Pull straight down when removing the probe from
the receptacle. Bending or pulling the probe at an
angle during removal may damage the probe and
oven. Do not place a rack or accessory in rack
position six when using the probe, as it interferes
with probe removal.
1
Preheat the oven to the desired oven temperature in
the desired mode.
2
Completely insert the probe into the thickest area of
the food.
When preheat is complete, place food in the oven.
3
4
Insert the connector into the probe receptacle, then
close the door.
5
Touch Probe on the touchscreen.
6
Touch Start/Enter on the control panel to select the
preset temperature. To change the temperature, use
the control panel to select the desired temperature,
then touch Start/Enter.
7
A chime indicates the temperature is 5°F (1°C) below
the set temperature. The oven chimes and the set
temperature flashes when the internal temperature
reaches the setpoint.
Remove, then reinsert the probe to verify the internal
8
temperature.
Touch the flashing temperature to clear.
9
|
wolfappliance.com
11