Important Safeguards; Auto Shut-Off - Russell Hobbs 24650-56 Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
Read the instructions, keep them safe, pass them on if you pass the iron on.

IMPORTANT SAFEGUARDS

Follow basic safety precautions, including:
This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of
experience and knowledge if they have been supervised/instructed and
understand the hazards involved. Children shall not play with the
appliance. Cleaning and user maintenance shall not be done by children
unless they are older than 8 and supervised. Use and store the appliance
out of reach of children under 8 years.
Use the iron, or set it on its heel, on a stable, level, heat-resistant surface,
preferably an ironing board.
Don't leave the iron unattended while plugged in, or while it's standing on
the ironing board.
Unplug the iron before filling, before cleaning, and after use.
Don't operate the appliance if it's dropped or damaged, or if it
malfunctions or leaks.
If the cable is damaged, return the iron in order to avoid a hazard.
¬ The surfaces of the appliance will get hot during use.
Don't put the appliance in liquid, don't use it in a bathroom, near water, or outdoors.
Never iron clothing while it is being worn.
Don't use the appliance for any purpose other than those described in these instructions.
Don't scratch the soleplate – avoid buttons, zips, etc.
The appliance has a protective thermal fuse which will blow if it overheats. If this happens, the
appliance will stop working, and must be returned for repair.
PARTS
1.
Temperature control
2.
Soleplate
3.
Heel
4.
Light
5.
Steam control
BEFORE USING FOR THE FIRST TIME
Remove labels, stickers and packaging from the iron and soleplate.
Don't worry if the iron smokes a little at first. It will stop after a short time.
Iron an old piece of cotton fabric, to clean the soleplate.

AUTO SHUT-OFF

If the iron is motionless, it will switch off after about 30 seconds with the soleplate down or on its
side, or about 8 minutes if it's upright.
The light will flash and keep flashing till you move the iron.
To switch on again, lift it up, tilt it forward, then sit it upright to return to operating temperature.
No settings are lost during auto shut-off.
PREPARATION
Check for textile care symbols (i j k l).
1.
Iron fabrics needing low temperatures j first, then those that need medium temperatures k, and
2.
finish with those needing high temperatures l.
HOUSEHOLD USE ONLY
6.
7.
8.
9.
3
Water inlet
Cover
Spray nozzle
Mark

Publicidad

Tabla de contenido
loading

Tabla de contenido