How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation SLINGER v2 Manual Del Usuario

Ocultar thumbs Ver también para SLINGER v2:

Manual de instrucciones (38 páginas)

Tabla de contenido

Idiomas disponibles

NOTE: This step is applicable after the neccessary wiring is completed.

1. Assemble canopy by rotating key slot in canopy over

shoulder screw in hanger bracket

the wires.

Tighten shoulder screw. Fully assemble and

tighten second shoulder screw that was previously

removed. (Figure 1)

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy

housing and not pinched between the housing and the

ceiling.

Securely attach and tighten the canopy screw cover

over the shoulder screws in the hanger bracket utilizing

the keyslot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

Lay the blade holders with the threaded posts and

pitched foot facing up. Position the blades over the

blade holders with the threaded posts showing. Make

sure the bottom edge of the blades is fully seated

against the blade holders. Place blade covers on top

of the blades, positioning the holes over the threaded

posts. Tighten pan-head screws to secure the blades

to the blade holders. (Figure 1)

CAUTION

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled

may result in damage to the fan blades.

2. Secure the blade holders to the hub of motor

NOTE:

Periodically check blade holder hardware and

resecure if necessary.

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades

or cleaning the fan. Do not insert foreign objects in

between the rotating blades.

To reduce the risk of electric shock, disconnect the

electrical supply circult to the fan before installing

light kit.