测量值显示 - Phoenix Contact EMpro EEM-MA400 Instrucciones De Montaje Para El Instalador Eléctrico

可显示用于通信模块的相应组态菜单。 有关必须的组态设置，请查询
获取测量设备的用户手册。
Configuration mode:
Mains types:
Current transformer:
Measuring time for currents to
calculate MAX values:
Measuring time for real power to
calculateMAX values:
Reset measured values / times:
LCD display:
Operating hours counter:
see extension module
Serial number:
Software version:
C：图 9 流程图
5.3 测量值显示
通过按键获取测量值。
可通过数次按下按键的方法显示选择菜单中更详细的测量值。 在相应的用户手册中可找到更多细节。
按键 显示
I 电流，电流的总谐波失真 （THD）
U F 电压，频率，电压的总谐波失真 （THD）
P PF 功率，功率因数 （LF）
E 电量
104512_zh_02
100
4NBL, 3NBL, 4BL, 3BL, 2BL , 1BL
Set primary current
20' min; 30' min; 60' min; 2'' sec; 5' min; 8' min; 10' min; 15' min
20' min; 30' min; 60' min; 2'' sec; 5' min; 8' min; 10' min; 15' min
I: Maximal value of the currents
P: Maximal real power value
EA: active energy (+kWh)
ER: reactive power (+kVArh)
HOUR: operating hours counter
AUX: illuminated, if supply voltage is available
I: illuminated, if current is being measured
U: illuminated, if voltage is being measured
for AUX: Illumination goes out automatically after 2 minutes.
The display is illuminated again after pressing any key.
AUX: activated, if supply voltage is available
I: activated, if threshold value is set (input current)
U: activated, if threshold value is set (input voltage)
Threshold value:
I / U
▼
Press until you reach menu item Ser l :
serial number is displayed
▼
Press until you reach menu item SOFt:
software version is displayed
www.phoenixcontact.net/catalog
Yes; No
Set value
PHOENIX CONTACT
中文
以
9