Insuring Your Lawnmower; Assembly; Assembly Components (3); Bonnet(5:A) - Stiga Villa 2WD Serie Uso Y Mantenimiento

(Translation of the Original Instructions)
• Adhere strictly to local regulations governing the
disposal of cuttings.
• When the machine is withdrawn from service,
do not dump it in the environment, but take it to
a waste disposal facility in accordance with the
local regulations in force.

4 INSURING YOUR LAWNMOWER

Check the insurance on your lawnmower.
Contact your insurance company.
You ought to have fully comprehensive insurance
for traffic, fire, damage and theft.

5 ASSEMBLY

The battery must be fully charged befo-
re being used for the first time.
Do not use the machine until all the in-
dications provided in the "ASSEMBLY"
section have been carried out
Unpacking and completing the assem-
bly should be done on a flat and stable
surface, with enough space for machi-
ne handling and its packaging, always
making use of suitable equipment
5 1

ASSEMBLY COMPONENTS (3)

The machine is delivered with the seat, armrests,
steering wheel, tow bar, quick-fit supports
dismantled. The battery is in its housing but not
connected.
The packaging holds the components needed for
assembly (3) as listed in the table below:
Pos. No. Description
Contents of the bag
A 1 Tow bar
B 2 Flanged screw
C 2 Screw for battery
D 2 Nut for battery
E 6 Washer
F 2 Shoulder washer
G 4 Screw
H 2 Screw knob
I 2 Ignition key
J 1 Pin
K 1 Shim
L 1 Shim
P 2 Screw
ENGLISH
Q
R
Installed on the front semi-axles
M
N
Attached to the tool lift
O
5 2
[Gear]
1 Set the lever (12:A; 12:B) to the forward
[Hydrostatic]
1 Set the lever (13:A) to the forward position.
2 Lift the seat stopper (7:S) and fold the seat
3 Open the bonnet: take hold of the edge (5:A)
4 Perform the above operations in reverse or-
5 3
For the type of battery installed on the machine,
please refer to "0 TECHNICAL DATA TABLE"
Dimensions

5 3 1 Battery connection (6)

Connect the battery to the machine's electrical sy-
/
stem using the relative screws and nuts (6:F; 6:E):
8 x 20
/
1 Connect the red cable to the battery's posi-
/
8,4 x 24 x 2,0
2 Connect the black cable to the battery's ne-
/
8 x 20
/
/
6 x 36
16 x 38 x0,5
16 x 38 x 1,0
M10 x 35
2 Nut
2 Split lock washer
2 Safety rings
2 Washer with internal wing
2 Deck mount

BONNET(5:A)

Open the bonnet to access the fuel cock,
battery and engine.
The bonnet can be opened as follows:
position.
forward.
and lift.
der to close the bonnet.
It is strictly prohibited to start the engi-
ne when the bonnet is open

BATTERY

CAUTION! Battery acid is corrosive and
contact with it is harmful
Handle the battery with care taking care
not to let acid leak out
Do not check or top up the battery fluid.
tive terminal (+).
gative terminal (-).
If the leads are disconnected/con-
nected in the wrong order, there is a
risk of a short-circuit and damage to the
battery
Inverting the cable connections will da-
mage the alternator and the battery
EN
M10
14 x 8,2 x 2
/
/
/
11