Tyre Pressure; Accessories; Controls; Mechanical Accessory Lift Pedal (11:A) - Stiga Villa 2WD Serie Uso Y Mantenimiento

(Translation of the Original Instructions)
the work tool in the cutting-means assembly arms
(10:O).
5 8

TYRE PRESSURE

For the tyre pressure, please refer to chap. "0
TECHNICAL DATA TABLE".
5 9

ACCESSORIES

For installation of accessories, see the installation
guide accompanying each accessory.
Note: In this case the cutting device
assy is considered an accessory

6 CONTROLS

6 1 MECHANICAL ACCESSORY LIFT PE-
DAL (11:A)
The control lever (11:A1) is used to take the
accessories from the operating position to the
transport position.
• Transport position: press the pedal right down
then lift your foot off: the pedal stays down.
• Working position: press and slowly release the
pedal.
Do not attempt to switch to the tran-
sport position while the hooked-up
accessory is in operation This will de-
stroy the drive belt
6 2 PARKING BRAKE PEDAL mod :[Gear]
(11:B)
Combined brake/clutch pedal. The pedal (11:B)
has the following three positions:
engaged. If the machine is in
gear and the pedal is
released, the machine will
move accordingly. The brake
is not on.
Pressed to halfway: Forward drive disengaged.
In this position it is possible to change gear. The
brake is not on.
Pressed right down Forward drive disengaged.
The brake is on.
Do not regulate driving speed by acting
on the clutch pedal and letting it slip
Put the machine a more suitable gear
Released: Forward drive
ENGLISH
6 3 PARKING BRAKE MODELS: [Hydrosta-
tic] (11:B)
The pedal (11:B) has the following three positions:
brake is not activated.
Pressed right down Forward drive disengaged.
The parking brake is fully activated but not locked.
This position is also used as an emergency brake.
6 4 PARKING BRAKE LOCKING LEVER
(11:C)
The lever locks the "brake" pedal in the
pressed right down position. This function
is used to lock the machine on slopes, du-
ring transport, etc., when the engine is not running.
Locking:
1 Press the pedal (11:B) right down.
2 Move the locking lever (11:C) to the right.
3 Release the pedal (10:B).
4 Release the locking lever (11:C).
Unlocking:
1 Press and release the pedal (10:B).
6 5

TRACTION PEDAL [Hydrostatic] (13:E)

The pedal determines the gearing ratio between
the engine and the drive wheels (= the speed).
When the pedal is released, the service brake is
activated.
- Press the pedal forward – the
machine moves forward.
- No load on the pedal – the machine is
stationary.
- Press the pedal backward – the
machine reverses.
- Reduce the pressure on the pedal – the machine
brakes.
A plate is installed on the upper section of the pe-
dal which can be adjusted to suit the driver's foot.
If the machine does not brake as ex-
pected when the pedal is released, the
left pedal (11:B) should be used as an
emergency brake
6 6

STEERING WHEEL (If scheduled) (13:H)

The height of the steering wheel is fully adjustable.
Unscrew the adjustment knob (13:D) on the stee-
Released: The clutch is not
activated. The parking brake is
not activated.
Pressed to halfway: Forward
drive disengaged. The parking
EN
13