HoMedics envira Scape Manual De Instrucciones E Información De Garantía página 3

Assembly and Instructions for Use
1. Unpack the product. Wipe off dust with a damp cloth.
2. Familiarize yourself with the pump. The pump speed is controlled by the switch
located at the front of the pump. The speed is indicated by a plus (+) and minus (-)
sign. To increase the speed, move the switch slowly downward in the direction of
the plus sign. You will hear a click as the switch moves to each speed level. At its
highest speed level, the switch will cease to move any further. To decrease the pump
speed, move the switch upward toward the minus sign. Similarly, at its lowest speed,
the switch will cease to move any further (Fig 1).
NOTE: It is recommended the pump be set at its highest speed during assembly
and later adjusted to a lower setting if desired. Be sure to unplug the pump before
adjusting the speed setting.
A t t e n t i o n :
Figure 1
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL T H E
T I M E .
3. Insert the rubber end of large waterproof light into the light clip located inside the
base.
(Fig.2) Slight twisting may help to push the rubber end through the clip more easily.
Note: Be gentle with the bulb cover since it is made of glass.
4. Lead the power cord for the pump and small light up through the cord slot
located on the back wall of the base. (Fig. 3)
5. Insert the plastic tube attached to the fountain top through the tube slot located on
the back wall of the base. (Fig. 4)
6. Be sure the fountain top is sitting level on the base and then secure down using
washers and screws. (Fig. 4)
Note: You will need a screwdriver to assemble. (Not included)
7. Insert the small waterproof light into the light hole located on the back of the
fountain top. (Fig. 5) Slight twisting may help to push the rubber end through
the clip more easily
Note: Be gentle with the bulb cover since it is made of glass.
Note: Be sure that the rubber plug at the end of the small waterproof light is
securely plugged to prevent water leaking.
Figure 2
Light Clip
Large Waterproof Light
Minimum Water Level
Flow Control Va l v e
(+) faster water output
(-) slower water output
Figure 3
Cord Slot
Pump
Power Cord
Base
4
8. Insert the black connector at the bottom of the plastic tube into the round opening of
the pump. (Fig. 6)
9. Fill the base with approx. 96 oz. of water. (Fig. 7)
Note: We recommend using distilled water to help prevent mineral build-up.
10.Place the screen on the support tabs of base. (Fig. 8)
11.Attach the A/C adapter jack to the base power cord. (Fig. 9)
12.Plug the cord into 120V household outlet. The fountain is controlled by a switch
located on the power cord. If pump does not operate, rotate in-line switch once to
turn "on" and once to turn "off".
Note: Ensure that the electrical cord loops below the electrical outlet to form a
"Drip Loop". This will prevent water from running down the electrical cord into the
electrical outlet. (Fig. 10)
Figure 4
Screw
Washer
Plastic
Tube
Pump
Base
Tube Slot
Figure 5
Light Hole
Small Waterproof Light
(Back of Fountain)
Figure 6
Plastic Tube
Pump
Figure 7
Water
Figure 8
Screen
Support Tabs
Figure 9
Power Cord
AC Adapter
5