HoMedics envira Scape Manual De Instrucciones E Información De Garantía página 4

Fuente de relajación con luz
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Figure 10
Drip Loop
M a i n t e n a n c e
• To clean the pump:
Unplug from electrical outlet. Remove it from the base of the fountain.
Use a small brush or stream of water to remove any debris (Fig 10).
• To keep water clean:
Periodically change water and clean the product according to the water
condition. Keeping the water clean prevents the water from becoming
sticky and forming micro-organisms. We recommend distilled water to
prevent mineral build-up.
• To clean off hard water deposits on the base:
Soak the container in a mixture of vinegar and water to clean and
remove any mineral build-up.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level to avoid
shortening the life of the pump.
NOTE: Never let the pump run dry, as this will shorten
the life of the pump.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water, and store
fountain in a dry, cool place.
6
• Changing Light Bulbs
First unplug fountain and let bulb cool down. Remove the bulb cover by
holding glass bulb cover in dry hand and rubber neck with other hand.
Slowly pull apart. Slight twisting may help to loosen. Be gentle with bulb
cover since it is glass. Never pull on cord. Next pull bulb straight out and
replace with new bulb, inserting prongs into the holes.
Replace bulb cover securely.
Figure 10
PVC Tubing
Inserts Here
Impeller
Pump Inlet
Front Plate
Suction Feet
Flow
Control
Lever
Tr o u b l e s h o o t i n g
C a u t i o n :
• If the pump fails to operate, check the following:
All servicing
Check the circuit breaker, or try a different outlet to make
of this fountain
sure the pump is getting electrical power.
must be
performed
NOTE: Always disconnect from electrical outlet
before handling the pump.
by authorized
HoMedics
• If the pump gurgles, spews, or "burps":
service
Check the water level to make sure the pump has enough
personnel only.
water to function.
•Obtaining a desired water level:
Check the water level daily the first week to measure the rate
of evaporation; refill with water as needed.
•If water is splashing outside the fountain:
Adjust the flow control valve to a lower setting on the pump.
7
I L L U M I N A T E D R E L A X AT I O N F O U N T A I N
Replacement Parts Order Form
PA R T
D E S C R I P T I O N
Back Plate
P P-W F L B U L B 2
Replacement bulbs and covers for
W F L-ITL (Large Light) - pack of 5
P P- R O C K B L B
Replacement bulbs and covers for
W F L-ITL (Small Light) - pack of 5
Housing
Mail To :
H o M e d i c s
Consumer Re l a t i o n s
Service Center Dept. 168
3000 Pontiac Tr a i l
Commerce Township, MI 48390
e-mail:
c s e r v i c e @ h o m e d i c s . c o m
Detach and return order form with check or money order payable to HoMedics, Inc.
Please allow 2 to 4 weeks for delivery.
N a m e
A d d r e s s
C i t y
T M
ITALIAN
GARDENS
Q U A N T I T Y
C O S T
$ 5 . 0 0
$ 5 . 0 0
S U B TOTA L
TAX-Michigan Residents add 6%
To t a l
(
)
S t a t e
Zip Code
Phone Number

Publicidad

Tabla de contenido
loading

Tabla de contenido