User Interface; Voice Prompts - Mach Power HC-AED7000 Manual Del Usuario

3.4

User Interface

3.4.1 Controls
The AED7000 is designed for ease of operation. After putting the defibrillator pads on the patient
and connecting them to the AED7000, the operator performs this simple three-step process:
1. Turn the power ON.
2. Follow LED prompts on the panel and voice prompts from the speaker.
3. If prompted, deliver shock by pressing the flashing red Shock button.
Power ON/OFF: Green On/Off button to toggle system power on/off.
Shock: Red Shock button to discharge defibrillator, red LED flashes when defibrillator is fully char-
ged.
3.4.2 LED Prompts
Operating information and user instructions display in these light-emitting diodes.
Check Pad LED Flashes: Defibrillator pads are not properly attached to the patient or are not proper-
ly connected to the AED7000.
Caution LED Flashes Do not touch or move the patient.
Analyzing LED Flashes: ECG leads are properly connected and the system is assessing the patient's
heart rhythm.
3.4.3

Voice Prompts

The AED7000 prompt feature provides instructional prompts to guide the user through the defibril-
lation process.
The AED7000 provides audio instructions through the built-in speaker to provide operating in-
struction and assist the user during defibrillation.
The voice prompts are listed in the following table.
1
Check the electrodes
2 Shock cancelled, check the electrodes.
3 Shock delivered
4 Time out, analysis restart.
5 Analyzing, do not touch the patient.
6 Charging, do not touch the patient
7 No shock advised
8 Press flashing shock button.
9 Stop CPR, start analysis ten seconds later.
10 Low Battery
11 System failure
Patient may be touched. Carry on CPR. Alternately give 30 chest compressions and 2 mouth-to-
mouth breaths. Now give 30 chest compressions. Now give 2 mouth-to-mouth breaths (Four Cycles)
16 16