Etac Molifit Air Tift Manual De Usuario página 9

Slings
This list of SilvaLea Clip Sling sling series are tested to be used
with Molift Air Tilt Sling bar.
The SilvaLea slings are available in sizes S – XL, in polyester.
Complete list of slings and sling bars can be found on etac.com.
Silvalea High Easy Toileting Sling Poly. (Toilet)
Size: Art.no:
S DA-ST3ASM
M DA-ST3AMED
L DA-ST3ALRG
XL DA-ST3AXLRG
Silvalea High Easy Sling Poly (HighBack)
Size: Art.no:
S HYASMCP
M HYAMEDCP
L HYALRGCP
XL HYAXLRGCP
Slings made by other manufacturers
Etac shall not be liable for faults or accidents that can occur when
using slings made by other manufacturers.
Troubleshooting
Symptom
The hoist does not respond to
hand control action.
Possible Cause/Action
Emergency Stop on the hoist
is activated. Deactivate by
pushing button back in.
The hoists electronics is
overheated.
Wait for it to cool down.
Hand control is not plugged in
properly. Hand control or plug
or cord can be broken and
should be replaced.
Actuator cable is not plugged
in properly.
Cleaning / Disinfection
Clean on a regular basis. Clean surfaces with a damp cloth
using an appropriate pH-neutral detergent. Do not use solvents
or strong liquids, this may damage surfaces on the hoist. For
disinfection when needed; use isopropyl alcohol. Avoid abrasive
cleaning products. Do not expose electronics to running water.
Make sure not to damage or remove labels
when cleaning.
Periodic inspection scope
This accessory shall be inspected as a part of the periodic inspec-
tion of the hoist it is used with.
Periodic Inspection shall be performed at least once a year or
more frequently if required by local requirements. The inspection
must be performed by service personnel authorized by Etac.
Contact Etac at molift@etac.com for training and
authorization or recommendation of an approved service partner.
If there is any problems that could jeopardize
someones safety, the accessory shall imme-
diately be taken out of service and marked
"out of order". Do not use untill it is repaired.
Service scope
Service involves replacing the actuator and inspection/replace-
ment of worn parts. This must be carried out by authorized
personnel. Contact your local Etac dealer, or see etac.com for a
recommendation of an approved service partner.
Before use / Daily check
Inspection to be performed by caregiver daily or before use:
Make sure sling bar connection is properly connected and
secured.
Make sure wiring, hand control, clip studs or joints do not
have any visible damage.
If there are any faults or defects, the Molift Air Tilt needs to be
taken out of operation and marked "out of order".
6
Molift Air Tilt / www.etac.com