Tractel LDR 06 Manual De Instalación, De Utilización Y De Mantenimiento página 7

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
halyard
stranded cord
n: diameter of anchor point to use.
13. Periodical inspection and repair
A  regular  yearly  inspection  is  mandatory.  However, 
depending  on  the  frequency  of  use,  environmental 
conditions  and  regulations  of  the  company  or  the 
country  of  use,  periodical  inspections  can  be  more 
frequent.
Regular  inspections  should  be  carried  out  by  an 
approved and qualified technician and in accordance 
with  the  manufacturer's  examination  procedures 
as  laid  down  in  the  TRACTEL
Procedures" manual.
Verification  of  the  legibility  of  the  marking  on  the 
product is an integral part of the periodical inspection.
Following  the  periodical  inspection,  a  certificate  of 
return  to  service  must  issued  by  the  approved  and 
competent  technician  who  performed  the  periodical 
inspection. This return to service must be recorded on 
the inspection sheet in the middle of this manual. This 
inspection sheet should be retained throughout the life 
of the product until it is scrapped.
Once  it  has  arrested  a  fall,  this  textile  product  must 
be  disassembled  and  destroyed,  even  if  there  is  no 
visible deformation.
14. Lifecycle
The  Tractel
  textile  PPE  components  such  as 
®
harnesses, lanyards, ropes and shock absorbers, like 
the  Tractel
  mechanical  PPE,  such  as  Stopcable™ 
®
and  Stopfor™  fall  arresters,  the  Blocfor™  automatic 
retraction  fall  arresters  and  Tractel
be  used  provided  that  counting  from  the  date  of 
manufacture they have been subject to:
– in 
normal 
use 
in 
recommendations of use in this manual.
– a  periodical  inspection  that  must  be  accomplished 
at least once a year by an approved and competent 
technician. At the end of this regular inspection, the 
PPE  must  be  certified  in  writing  to  be  fit  to  return 
to service.
– strict  compliance  with  the  storage  and  transport 
conditions specified in this manual.
15. Disposal
When  disposing  of  the  product,  it  is  mandatory  to 
recycle the various components after sorting metallic 
materials  and  sorting  synthetic  materials.  These 
  "PPE  Verification 
®
lifelines can
®
accordance 
with 
the 
materials  should  be  recycled  by  specialised  centres. 
During disposal, dismantling to separate components 
should be achieved by a duly trained person.
GB
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lcm 06

Tabla de contenido