Components And Materials; Additional Equipment - Tractel LDR 06 Manual De Instalación, De Utilización Y De Mantenimiento

components have been replaced by a person who is
not approved by TRACTEL
• use the LCM 06 work support lanyard with anything
GB
other than a TRACTEL
rope.
• Insofar as is possible, the structural anchor point
should be above the operator. The anchor point must
present a minimum resistance of 12 kN.
• The connection to an anchor point or to the structure
must be achieved using an EN 362 connector.
• To connect the work position securing lanyard to the
work position support belt, please refer to the support
belt manual in order to use the correct connection
point and the correct attachment method.
To use this equipment, follow the instructions
hereinafter:
• It is mandatory to position the lanyard around a
tubular support or another structure before starting
to climb.
• Check that the connectors are fully locked.
• Adjust the length of the lanyard so that any free fall
is limited to 0.5 m. The adjustment should be done
with the lanyard under tension, as the automatic
tensioner has been designed to work with the
lanyard under tension.
• The lanyard should never be positioned at a height
lower than the operator's abdomen (fi gure 2.b).
Before and during use, you should consider how
any rescue could be provided effectively and
safely within a period of less than 15 minutes.
Beyond this time the operator is in danger.

8. Components and materials

• Braided rope polyamide cord: ∅ 11 mm.
• LCM 06 Tensioner: stainless steel, aluminium, plastic
• Reduction gear: aluminium.
• Connectors: galvanised steel, aluminium

9. Additional equipment

System for work position support (EN 358):
• A connector (EN 362).
• A work position support belt (EN 358).
6
.
®
supplied 14mm stranded
®
7. Installation
DANGER
10. Maintenance and storage
If a work position securing lanyard is dirty, it should be
washed in clear, cold water with a delicates detergent
if necessary. Use a synthetic brush.
If during use or washing a work position securing
lanyard has been wetted, you must let it dry naturally
in the shade and away from any heat source.
During transport and storage, protect the equipment
in waterproof and hazard proof packaging (direct heat
source, chemicals, ultra violet, etc.).
Figure 3.
11. Conformity of the equipment
TRACTEL SAS RD 619 – Saint-Hilaire-sous-
Romilly – F-10102 Romilly-sur-Seine France
hereby declares that the safety equipment
described in this manual,
• complies with the provisions of European Directive
89/686/CEE of December 1989,
• is identical to the PPE that was the subject of the CE
inspection issued by APAVE SUDEUROPE SAS, CS
60193, 13322 Marseilles cedex 16 registered under
No. 0082, and tested according to the Standard
EN 358 of 1999,
• is subject to the procedure referred to in Art. 11B
of Directive 89/686/CEE under the supervision of
an approved body: APAVE SUDEUROPE SAS –
CS 60193 – 13322 Marseilles – France, registered
under number 0082.
12. Marking
The information label on each equipment item shows:
a. The trademark: TRACTEL
b. The product description,
c. The reference standard followed by the year of
application,
d. The product reference
e. The CE logo followed by the No. 0082 of the notifi ed
body responsible for production inspection,
f. Year and month of manufacture,.
g. The serial number,
h. An icon indicating that the manual must be read
before using the equipment,
w. Maximum working load,
i: an arrow indicating the direction of use.
k: the location of the anchor point,
m: the only type of anchor point to be used.
,
®