auna TT-138 DAB Manual De Instrucciones página 22

EN
22
display will show "preset ¬¬_ stored".
6. Repeat step 2 to 5 to store other stations.
Recall preset stations
1. Press the Pre / Memory button (10) once to enable recall state
2. Rotate the Push Select button (12) to select the desired memory station.
3. Press Push Select button (12) to confirm the recall the memory station.
• The pre-set memories will be cancelled completely if disconnecting
the main power supply and back up battery did not installed. You are
recommended to switch the system into standby mode for convenience
usage.
• There are 3 seconds for program state, after 10 sec. This state would
resume to normal tuner mode automatically.
• You can overwrite a present station by storing another frequency in its
place.
Hints for best reception: FM the receiver has an external FM wire antenna to
connect to the antenna socket at the back of the unit. This antenna should
be totally unravelled and extended for best reception. Move the antenna to
obtain the best reception.
Language setting
This device provides 5 language for FM/DAB operation display.
1. In DAB/FM mode, Press and hold the Menu/Info button (3) to enter
the "Menu", then press Skip up / down button (7) button to select
"Language ".
2. Press Select button (9) to enter language mode setting, then press Skip
up / down button (7) button to select your desired language between
English/ German/ French/ Italian. Then press Select button (9) to confirm
the setting.
3. In any state press Menu/Info button (3) to quit the setting mode.
DAB/FM reset :
If case would like to erase all the FM/DAB programmed memory station,
operation as below.
1. Set in DAB or FM mode, Press and hold the Menu/Info button (3) to
enter the "Menu", then press Skip up / down button (7) button to select
"Reset".
2. Press the Push Select button (12) to enter and the display will show
"Press Enter to confirm reset...". Apparatus will erase all the programmed
memory station, perform the preset station again as above.