Maintenance Schedule - Uline H-1394 Manual Del Usuario

INSTALLATION AND OPERATING INSTRUCTIONS CONTINUED
4. The legs are adjustable from 28⁄" to 41⁄" (724mm
to 1,054mm). The leg elevation is factory set at 28⁄"
(724mm). For proper gravity flow, a 5/16" (8mm)
decline per expanded foot (305mm) is
recommended. This may vary with carton weight or
your specific applications.
5. To expand the conveyor:
a. Unlock the casters.
b. Grasp the handles on each side at both ends
of the conveyor and pull until the conveyor is
properly expanded.
c. Lock casters and begin use.
CAUTION! Move conveyor only by grasping the
handles located on each side at both ends of
the conveyor.
CAUTION! When expanding or compacting
your conveyor; keep hands, clothing and other
items clear of the side bars.
WARNING! Do not exceed the conveyor load
capacity, as it may result in possible operator
injury or conveyor damage.
Your conveyor is designed to be virtually maintenance
free. We do recommend that you regularly inspect the
unit to ensure proper operation of mechanical and
safety systems.
DAILY:
• Keep your conveyor free of dirt, debris and grease
accumulation.
• Inspect leg elevations and adjust, as necessary, to
ensure smooth product flow.
• Look for mechanical damage or worn components
and replace as necessary.
PAGE 2 OF 21
6. To set leg elevation for your application:
SAFETY

MAINTENANCE SCHEDULE

MONTHLY:
• Check to ensure that all bolts and nuts are
Required tools to maintain your conveyor include:
Two each of these size wrenches: 7/16", 1/2" and 9/16".
a. With the conveyor expanded, unscrew the
adjustment knobs on the first leg set on the
infeed end and lift up on the conveyor to height
needed. Tighten adjustment knobs.
b. Do the same on the last leg set on the
discharge end.
c. Adjust all legs in between to obtain proper
gravity flow.
d. Close conveyor and check for slopes and valleys
between the legs and readjust if needed.
CAUTION! Avoid wearing excessively loose
clothing when working with moving equipment.
CAUTION! Keep long hair pulled up to prevent it
from becoming caught in moving parts.
NOTE: Broken or worn parts must be
immediately replaced.
NOTE: Conveyors must only be serviced by
properly trained and qualified technicians.
moderately tight.
CAUTION! Do not over torque as this may cause
frame distortion and prevent the system from
properly flexing.
0521 IH-1394