3.
Remove the wall plate template
CAUTION:
Be sure the anchors C3 are seated flush with the concrete surface.
using four lag bolts C1 and four washers C2 (use ONLY the lag bolts and washers from the Concrete Installation Kit
4.
Install wall plate
16
CMK1*). Tighten the lag bolts C1 only until they are pulled firmly against the wall plate
CAUTION:
Improper use could reduce the holding power of the lag bolt. DO NOT over-tighten the lag bolts C1 .
*
*
Contact Customer Service at 1-888-333-9952 to have the Concrete Installation Kit CMK1 shipped directly to you.
Contact Customer Service at 1-888-333-9952 to have the Concrete Installation Kit CMK1 shipped directly to you.
3
and insert four anchors C3 (Fischer UX 10 x 60R - included in the Concrete Installation Kit CMK1*).
15
C3
.
16
4
C2
C1
16
15