Metra 99-2011 Instrucciones De Instalación página 24

All applications:
1. Locate the factory wiring harness and antenna
connector in the dash. Metra recommends
using the proper mating adapter from Metra or
AXXESS. Test the radio for proper operation.
2. Secure the completed assembly into the
dash and reassemble the dash in reverse
order of disassembly.
Metra. The World's Best Kits.
®
KIT ASSEMBLY
(CONT)
For the Cadillac Eldorado, Seville 1992-1995 only:
1. Align the tabs on the bottom of the radio trim plate/radio bracket
assembly with notches in the sub-dash. (Figure C)
1
2. Secure with the (2) carriage bolts and (2) Keps nuts provided. (Figure C)
Note: For the Buick Le Sabre, Oldsmobile Aurora, and the Pontiac Bonneville.
3. The (3) speed clips and screws provided with the kit will need to be
installed into the sub-dash where the screw holes line up on the kit.
(Figure C)
MetraOnline.com
I N S TA L L AT I O N I N S T R U C T I O N S
If you are having difficulties with the installation
of this product, contact our Tech Support line
either by phone at 386-257-1187, or email at
techsupport@metra-autosound.com. Before
doing so, look over the instruction booklet a
second time and ensure that the installation was
performed exactly as the instruction booklet
is stated. Have the vehicle apart and ready to
perform troubleshooting steps before contacting
Metra/Axxess Tech Support.
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
99-2011
K P
®
NOWLEDGE IS OWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
REV. 1/6/20 INST-99-2011