Access Panel - Bradley Verge LVQ Serie Manual Del Usuario

LVQD1
15

Access Panel

CAUTION For applications where children are present or for applications
subject to vandalism, order security screw option S45-2880.
Make all connections before installing access panel.
If access panel brackets were previously installed in Step
1, skip A and proceed to B.
Install access panel brackets
to wall using #10 fasteners
A
(supplied by installer) as
shown in rough in drawing.
Install top screw into slot. Do
not install bottom screw until
Step C is complete.
Insert #10 thumbscrews
into front bowl apron as
B
shown. Thumbscrew in
vertical position is closed.
Thumbscrew in horizontal
position is open.
Hang access panel onto
mounting brackets attached
to the wall, on the left and
right sides. Rotate panel up
C
and check fitup between
thumbscrews and panel slots.
Route access panel down
and make adjustment to
brackets if necessary. Install
bottom #10 fastener into
brackets.
D
Attach P-trap to drain adapter
and waste outlet.
E
Plug the grounding wire
assembly adapter from
WashBar to wall outlet.
Plug dryer power cord
from dryer motor into
GFCI protected wall outlet.
F
WashBar LEDs will light up
blue. Wait 5 seconds. Place
hands under soap dispenser,
water and dryer to be sure
all 3 functions work properly.
Check for water leaks.
22
#10
Thumb
Screw
#10 Top
Screw
Information
Label
Grounding Wire
Rotate access panel up
G
and secure by rotating
thumbscrews to the closed
position.
1/21/2021
Shown in closed
position. Rotate
90° to Open
Assembly
H
Bradley • 215-1842 Rev. H: ECO 20-08-028B
Installation
To open access panel, rotate
thumb screw, slightly push
panel up and swing access
panel down. Do not remove
thumbscrews.