Attach Soap Motor And Soap Container Bracket - Bradley Verge LVQ Serie Manual Del Usuario

Installation
5

Attach Soap Motor and Soap Container Bracket

Attach soap motor control box and soap
A
container bracket to wall using #10 screws
at the locations shown in the Structural
Rough-In drawing.
B
Attach soap syphon tube to the bottom
of the soap pump.
C
Install soap pump into the soap control box.
D
Secure soap pump to the soap control box
using the small hook and loop strap.
E
Slide the gallon soap container over
the soap syphon tube, and push the
soap container up into the soap pump
approximately ¹/₄" (6 mm).
F
Clear soap bracket and hold in place
against the wall.
The liquid soap pump has a rubber sleeve
that fits over the soap container opening.
The foam soap pump has an interior white
cylinder that fits into the soap container.
The fit may be tight. Move the gallon soap
container laterally while applying pressure
to seat them together approximately
¹/₄" (6 mm) into soap container opening.
Slide soap container bracket up until
G
it touches the bottom of gallon soap
container. Tighten the #10 screws to secure
the soap container bracket to the wall.
Remove the gallon soap container by
H
swinging it away from the wall and lowering
it from the soap syphon tube (see below).
Store soap container for later installation.
Bradley • 215-1842 Rev. H: ECO 20-08-028B
Attach soap
supply tube
here.
Soap Pump
(Liquid or Foam)
Alternate location
for adding a small
hook & hoop strap
to an older soap
pump assembly
Soap Motor
Control Box
Soap
Container
Bracket
Ensure soap pump flange
is positioned below control
lever box.
Small Hook &
Loop Strap
Liquid soap pump
shown. Foam soap
pump similar.
1/21/2021
LVQD1
Soap Syphon
Tube
Gallon
Soap
Container
15