Kohler K-6816 Manual Del Usuario página 13

Post
Sleeve
Shelf Bracket
9. Install the Glass Shelf
Insert a bearing into the mounted post. Align the holes in the
bearing with the hex slots on the post.
Slide the center cap over the mounted post. Align the holes in the
center cap with the hex slots in the post.
Slide a support bar through the bearing.
Place a sleeve over the bracket extension on a shelf bracket.
Screw the shelf bracket onto the support bar.
Place a sleeve over the opposite end of the support bar.
Screw a knob and washer onto the support bar.
Repeat this procedure for the remaining mounted post.
Start the setscrews into the shelf brackets. Make sure the
setscrews do not protrude into the inside of the shelf bracket.
Wet the end of the glass shelf with a mild soap solution.
Carefully slide the shelf into the brackets.
Adjust the shelf brackets as necessary to achieve level.
Tighten all setscrews.
Kohler Co.
Washer
Sleeve
Support Bar
Mounting Screw
Bearing
Bracket Center Cap
Extension
13
Knob
1020822-2-B