Kohler K-6816 Manual Del Usuario página 5

Wall Plate Hole Locations
1-3/8"
(3.5 cm) D.
11/16"
(1.7 cm) R.
2. Mark and Drill the Pilot Holes
Draw a 1-3/8" (3.5 cm) diameter circle around the accessory post
center point.
Position the wall plate over the circle and mark the three hole
locations.
NOTE: There is no provision for later adjustment if the center points
and the resulting pilot holes for multiple-post accessories are not
level with each another.
If your accessory requires multiple posts, verify the center points
are level.
NOTE: Use a 5/16" drill bit for horizontal tissue holder installations.
Use a 1/2" drill bit for all other accessory installations.
Set the wall plate aside, then drill a hole at each marked location.
Kohler Co.
Wall Plate
Holes
5 1020822-2-B