Kohler K-6816 Manual Del Usuario página 6

Horizontal Tissue Holder
Nail
3. Install the Wall Anchors
NOTE: You may need to disassemble some of the accessories. Some
accessories will be packed with the wall plate installed in the post.
Loosen the setscrew and remove the wall plate if needed.
For Horizontal Tissue Holder Installations
Press and hold the legs of a wall anchor together, then insert the
wall anchor legs into the hole. Insert all wall anchors into the
pre-drilled mounting holes.
Carefully tap each wall anchor into the finished surface. Ensure
the wall anchors are flush with the finished surface.
For All Other Accessory Installations
Hold the toggle anchor flat alongside the plastic straps and slide
it through the previously drilled hole.
With one hand, pull the looped end straight out (do not pull at
an angle) so that the toggle anchor rests flush behind the wall.
Slide the clip along the straps with your other hand until the
flange of the clip is flush with the wall.
Place your thumb between the plastic straps. Wiggle the straps
side-to-side until they snap off at the wall.
Insert the enclosed bolt through the wall plate and tighten until it
is flush with the wall.
Minimum clearance behind the wall is 1–7/8" (4.8cm).
1020822-2-B
All Other Accessories
Anchor Hole
Toggle Anchor
Loop
Strap
Loop
6
Clip
Kohler Co.