Assemble Chassis And Base; Fill Reservoir; Locate Place For Humidifier - Aircare Space Saver Serie Configurar La Guía Y El Manual Del Propietario

Assemble Chassis and Base

13. Align the chassis to the base. Starting at
the back, bring the two sections together.
IMPORTANT NOTE: The float rod must make contact
with the metal switch in order for the unit to operate
SOME DETAILS
OMITTED FOR
CLARITY

Fill Reservoir

CAUTION Turn unit off before filling.
NOTE Follow Cautions on page 5 regarding addi-
tives to water.
If desired, lift out the louvers at the front of
1.
the 831000 unit. Otherwise, pour cool water
into the reservoir through the louvers or grid
(depending on the model). Total capacity is six
gallons. Do not overfill as water will leak out
the overflow port.
2. Add bacteriostat per the instructions on the
bottle.
CAUTION Only pour water into the lower grille
CAUTION Do not allow water to spill onto the
motor or control panel. If the motor or controls get
wet turn unit off and allow them to dry completely
before turning unit on again.

Locate Place for Humidifier

1. Once unit is assembled and filled up, centrally
position the humidifier so the humidified air
flows throughout the house. Consider the
following points when identifying where to
locate the humidifier:
Tips for Positioning
• On level surface near an inside wall.
• Located for best flow through your home.
• At least 4 inches from wall.
• Not next to thermostat or hot air vent.
• Not by window (to avoid condensation).
FOR HELP, CALL 1.800.547.3888 OR VISIT AIRCAREPRODUCTS.COM
.
MODEL 831000
.
FILL HERE
7
MODEL 836000HB
OVERFLOW PORT
HUMIDISTAT