Taurus PROFESSIONAL RONER CLIP Manual De Instrucciones página 13

- Firmly lock the appliance by clamping it on the
side of your container.
- This appliance requires a 6-15 L container or
pot filled with water up to MIN level of the skirt
at least.
- Connect the appliance to the mains.
- The icon and working lamp will flash and it
will enter in stand-by mode. Press the
enter the setting mode. You will hear a sound
of beep.
- Select the desired cooking temperature using
the scroll wheel and confirm the setting with
the icon ºC/ .
- Select the desired cooking time using the scroll
wheel and confirm the setting with the
- The working illuminator will flash with 2 "beeps"
sounds when the appliance reaches the selec-
ted temperature and the time will countdown.
- If you want to change the setting, press and
hold the ºC/ icon for some seconds, and
then repeat the setting as above.
- When the cooking is finished, 3 "beeps" sounds
will be heard.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off pressing and holding the
icon for 3 seconds.
- Unplug the appliance from the mains.
- Clean the appliance.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and
off repeatedly, for reasons other than the
thermostat control, check to ensure that there
are no obstacles that impede correct air entry
or expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
SPECIAL MESSAGES:
When the EE1 message appears on the screen, it
may mean that:
- The water level is below the minium level.
- The appliance was taken out of the water
while it was working.
- The water has evaporated.
- The appliance is being used without water.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
icon to
task.
- Disassemble the appliance, hold the unit and
rotate the skirt in anticlockwise. (Fig.3).
- Turn the pump cap out of the lock position then
pull off. (Fig.4).
- Clean the electrical equipment and the mains
icon .
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- It is advisable to clean the appliance regularly
and remove any food remains.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
- The following pieces may be washed in a dish-
washer (using a soft cleaning program):
- Skirt
- Pump Cap.
- For cleaning the heating coil, pump shaft and
blade use dish soap, a soft tooth brush and
rinse under water. Do not rinse the top part of
the circulator including the main body in water.
- Then dry all parts before its assembly and
storage.
ANOMALIES AND REPAIR
- Take the appliance to an authorised technical
support service if product is damaged or other
problems arise. Do not attempt to disassemble
or repair the appliance yourself as this may be
dangerous.
- When the appliance work under an abnormal