Emerson SWEEP ECO Wi-Fi CF279BS00 El Manual Del Propietario página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Ceiling Fan Assembly
3.6
Separate, untwist and unkink the Five 80" Motor Wires.
Route the Five 80" Motor Wires through the 8" Downrod
(Figure 6).
3.7
Loosen the two Phillips Head Set Screws in the Motor
Coupler for installation of the Downrod (Figure 7).
Seat the Downrod in the Motor Coupler (Figure 7).
Rotate and align the Downrod holes with the two holes
in the Motor Coupler (Figure 7).
3.8
Slide the Clevis Pin through the Motor Coupler holes.
Install the Hairpin Clip through the Clevis Pin holes to
secure (Figure 8).
NOTE: The Clevis Pin must go through the holes in
the Motor Coupler. It is critical that the Clevis Pin is
properly installed and secure.
WARNING
!
It is critical that the clevis pin and hairpin clip in the
motor coupler are properly installed and secured.
Failure to verify that the pin is properly installed could
result in the fan falling.
(Continued)
Figure 6
LOOSEN
PHILLIPS HEAD
SET SCREWS (2)
Figure 7
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
Figure 8
7
8"
DOWNROD
MOTOR
COUPLER
MOTOR
COUPLER
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF279
HAIRPIN
CLIP

Publicidad

Tabla de contenido
loading

Tabla de contenido