Temperature Recall; Temperature Display - Toggle; Sleep Mode; Pulse Timer Mode - Covidien Genius 2 Manual De Instrucciones

en
8. The patient temperature and the probe eject icons will be displayed.
9. Press the eject button to eject the probe cover into a suitable waste receptacle.
10. Always return the thermometer to base for storage.

Temperature Recall

After a temperature has been acquired, the thermometer will enter "off" mode after approximately 10 seconds. The temperature
can be recalled by pressing and releasing the scan button or by pressing and holding the °C/°F button.
Temperature Display - Toggle °C or °F
When a temperature is in the display, the user may press and hold the °C/°F button to toggle between degrees Celsius and
degrees Fahrenheit.

Sleep Mode

The Genius™ 2 Tympanic Thermometer and Base enters sleep mode after 30-40 seconds of non-use. To wake up the thermometer,
eject the attached probe cover and/or install a new probe cover. This energy conserving function optimizes battery life.

Pulse Timer Mode

1. Press and hold the timer button to enter Timer mode. Press again to start the timer. The timer will run from 0 to 60 seconds.
2. The thermometer will issue a single beep at 15 seconds, a dual beep at 30 seconds, a triple beep at 45 seconds, and four beeps
at 60 seconds.
3. Pressing the timer button at any point during the timer function will return the thermometer to "off" mode.
4. At the end of the 60 seconds, the thermometer will wait two seconds and then enter sleep mode.
5. Return the thermometer to base for storage.
Tympanic Thermometer and Base
6 Table of Contents