Dynamic Weighing - OHAUS SD Serie Manual De Instrucciones

Auto Shut-Off
•
after approximately four minutes of inactivity. This feature is only active
during battery operation.

Dynamic Weighing

1. With platform empty, press the UNITS Cal button until the
2. Place a mass on the platform. The scale will show "-A-".
3. With a mass on the platform or container, a short press of
4. The averaged weight is then displayed. The indicator •
5. The display will hold until a button is pressed.
6. To repeat the process press UNITS Cal with a mass on the
7. To Exit, remove the mass from the platform or container and
1.800.544.2843
: To extend battery life, the scale will automatically turn off
indicator • flashes next to the desired measuring unit.
NOTE: If using a container, press ON/ZERO Off to tare the
weight and return to zero.
UNITS Cal will start the averaging countdown from
5 seconds.
stops flashing when the process is complete.
platform or container.
press UNITS Cal.
www.calcert.com
15
10 20
5 25
0 30
SD SERIES BENCH SCALE EN-7
sales@calcert.com