Basic Weighing; Turning On The Scale; Turning Off The Scale; Zero Operation - OHAUS TC3RS Manual De Instrucciones

Trooper Count Scale

3.2 Basic Weighing

The Trooper Count Scale has been factory calibrated and is ready for operation. Ohaus recommends that the Scale be
re-calibrated before use to ensure optimal accuracy. You can operate the scale at this point using the factory default
settings. You can check the default menu settings on page 14. All bolded items on the menu are the factory default
settings. The scale will operate in the default mode. If you want to change the settings, continue with Section 4, Setup.
When the Scale is positioned for operation, follow the operational procedure outlined next.

3.2.1. Turning On the Scale

Press and hold ON/ZERO Off button until the LCD
display appears. The display cycles as shown below
displaying "Ohaus", with model number, serial num-
ber, software revision number and weighing mode
display.

3.2.2 Turning Off the Scale

To turn the Scale off, press and hold the ON/ZERO Off
button until OFF is displayed.

3.2.3 Zero Operation

Press the ON/ZERO Off button to zero the weight dis-
play. The gross weight is also shown in the DATA
display.
NOTE: A pre-set tare value will not be zeroed.

3.2.4 Weighing

Place item to be weighed on the Scale. The display
indicates a sample of 1.5kg, gross weight.
WEIGHT
kg g
lb oz Net B/G %Ac
WEIGHT
kg g
lb oz Net B/G %Ac
WEIGHT
kg
g
oz
lb Net B/G %Ac
WEIGHT
kg
g
lb oz B/G %Ac
Net
WEIGHT
kg
g
lb oz B/G %Ac
Net
WEIGHT
kg g
lb oz Net B/G %Ac
WEIGHT
kg
g
lb oz B/G %Ac
Net
DATA COUNT
<
T PT APW MR M
DATA COUNT
<
T PT APW MR M
DATA COUNT
<
T PT APW MR
M
DATA COUNT
<
T PT APW MR M
DATA COUNT
<
T PT APW MR M
DATA COUNT
<
T PT APW MR M
DATA COUNT
<
T PT APW MR M
7
>
PCS
>
PCS
>
PCS
>
PCS
>
PCS
>
PCS
>
PCS