General Safety Precautions; Work Area Safety; Electrical Safety - Husqvarna PG 400 Manual Del Usuario

Ocultar thumbs Ver también para PG 400:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

General safety precautions

WARNING! This section describes basic
!
safety directions for using the machine. This
information is never a substitute for
professional skills and experience. If you get
into a situation where you feel unsafe, stop
and seek expert advice. Contact your dealer,
service agent or an experienced user. Do not
attempt any task that you feel unsure of!
Do not use the machine without first reading and
understanding the contents of this Operator's Manual.
Save all warnings and instructions for future
reference.

Work area safety

Do not use the machine in bad weather, such as dense
fog, rain, strong wind, intense cold, etc.
Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
The machine should not be used in areas where potential
for fire or explosions exist.

Electrical safety

WARNING! There is always a risk of shocks
!
from electrically powered machines. Avoid
unfavourable weather conditions and body
contact with lightning conductors and metal
objects. Always follow the instructions in the
Operator's manual to avoid damage.
Never connect the machine to a outlet if plug
or cord is damaged.
Check that the mains voltage corresponds with that stated
on the rating plate on the machine.
Inspection and/or maintenance should be carried out with
the motor switched off and the plug disconnected.
Always shut down the machine before disconnecting the
power plug.
Never drag the machine by means of the cord and never
pull out the plug by pulling the cord. Hold the plug to
disconnect the power cord.
Never use the machine if any cable or plug is damaged,
but hand it in to an authorized service workshop for repair.
The machine must never be driven to such a depth in
water that it reaches up to the machine's equipment. The
equipment can be damaged and the machine can be live,
resulting in personal injuries.
6 –
English
SAFETY INSTRUCTIONS
Grounding instructions
WARNING! Improper connection can result
!
in the risk of electric shock. Contact a
qualified electrician if in doubt as to whether
the appliance is properly grounded.
Do not modify the plug. If it will not fit the
outlet have a proper outlet installed by a
qualified electrician. Make sure local
regulations and ordinances are followed.
If the grounding instructions are not fully
understood contact a qualified electrician.
The machine is equipped with a grounded cord and plug
and should always be connected to a grounded outlet.
This reduces the risk of electric shock in the event of
malfunction.
The use of adaptors is not allowed with the machine.
Extension cords and cables
The marking on the extension cable must be the same or
higher than the value stated on the machine's rating plate.
Use grounded extension cables.
When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
Keep the connection to the extension cord dry and off the
ground.
Keep cable away from heat, oil, sharp edges or moving
parts. Damaged or entangled cable increase the risk of
electric shock.
Check that the cables are intact and in good condition.
Never use the machine if any cable is damaged, but hand
it in to an authorized service workshop for repair.
To avoid overheating do not use the extension cord while
it is rolled up.
Ensure the cord is behind you when you start to use the
machine so that the cord will not be damaged.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pg 280

Tabla de contenido