Abicor Binzel ABITIG WH 220WS Folleto De Instructiones página 4

EN
Torch necks in preferred sizes and geometries complete the ABITIG
Equipment parts and wear parts appropriate for the welding task at hand must be ordered
separately. The order data and ID numbers for the equipment parts and wear parts can be
found in the current product catalog. Contact details for consultation and placing orders can be
found online at www.binzel-abicor.com. The ABITIG
original ABICOR BINZEL spare parts only.
WARNING
Hazards caused by improper use
If improperly used, the device can present risks to persons, animals and material property.
• Use the device according to its designated use only.
• Do not convert and modify the device to enhance its performance without authorization.
• Only qualified personnel are permitted to perform work on the device or system.
NOTICE
• The manufacturer is not responsible for the transport and handling of the torch once it
leaves the factory.
• Prior to initial commissioning, check the torch against the alignment gage and make
adjustments as needed.
• Consult the documentation for the welding components.
Technical data
Type Type of
cooling
220WS Liquid
400WS Liquid
400WSK Liquid
Tab. 1 EN product-specific torch data with reference to EN 60974-7
1According to EN 60974-7, the value for the alternating current (AC) with 70% of the tested direct current
value (DC) must be specified.
EN - 2
Load DC Electrodes ø Gas flow
1
DC AC
A A % mm
220 160 100 1.0–3.2
400 280 100 1.6–4.8
400 280 100 1.6–4.8
®
®
WH torch system may be operated using
Cooling data
rate
Supply
temperature
Max.
L/min °C
6–16 50
5–22 50
5–22 50
BEI.0121.0 • 2020-02-14
®
ABITIG WH
WH torch system.
Flow Flow
pressure
Min. Min. Max.
L/min bar bar
0.5 2 4
0.5 2 4
0.5 2 4