Connections - Metra 99-6514B Instrucciones De Instalación

From the 16-pin harness with stripped leads to the aftermarket radio:
• Connect the Red wire to the accessory wire.
Note: If also installing an ASWC-1 (sold separately), there will be a Red wire on the 6514
harness to connect as well.
• Connect the Orange/White wire to the illumination wire, if applicable.
• If the vehicles equipped with a factory amplifier, connect the Blue/White wire to the amp
turn-on wire.
The following (3) wires are for aftermarket multimedia/navigation radios that require these wires:
• Connect the Light Green wire to the parking brake wire.
• Connect the Blue/Pink wire to the VSS or speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
• Tape off and disregard the following (9) wires, they will not be used in this application:
Brown, White, White/Black, Gray, Gray/Black, Purple, Purple/Black, Green, Green/Black
From the 6514 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Gray wire to the right front positive speaker output
• Connect the Gray/Black wire to the right front negative speaker output

CONNECTIONS

• Connect the White wire to the left front positive speaker output
• Connect the White/Black wire to the left front negative speaker output
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
• Tape off and disregard the following (4) wires, they will not be used in this application:
Purple, Purple/Black, Green, Green/Black
• Disregard the Yellow RCA jack labeled (1), it will not be used in this application.
• Connect the Yellow RCA jack labeled (2) to either an aftermarket backup camera, or an
AUX video input.
• Connect the Red & White RCA jacks to the audio AUX-IN jacks.
12-pin pre-wired ASWC-1 harness:
• The 12-pin harness is to be used along with the optional ASWC-1 (sold separately) to retain
steering wheel controls. If the ASWC-1 is not being used, disregard this harness. If it will be
used, please refer to the ASWC-1 instructions for programming. Disregard the harness that
comes with the ASWC-1.
5
REV. 8/13/2019 INST99-6514B