Connections To Be Made - Metra 99-7510 Instrucciones De Uso E Instalación

From the 7510 harness to the aftermarket radio:
• Connect the Black wire to the ground wire.
• Connect the Yellow wire to the battery wire.
• Connect the Red wire to the accessory wire.
• Connect the Blue wire to the power antenna wire.
• If the vehicle is equipped with a factory amplifier, connect the Blue/White
wire to the amp turn on wire. This wire must be connected to hear sound
from the factory amplifier .
• If the aftermarket radio has an illumination wire, connect the Orange wire to it.
• Tape off and disregard the Orange/White wire, it will not be used in this application .
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Green wire to the left rear positive speaker output.
• Connect the Green/Black wire to the left rear negative speaker output.
• Connect the Purple wire to the right rear positive speaker output.
• Connect the Purple/Black wire to the right rear negative speaker output.
99-7510

Connections to be made

The following steps are only for multimedia/navigation radios that require these wires.
6
®
• Connect the Blue/Pink wire to the VSS/speed sense wire.
• Connect the Green/Purple wire to the reverse wire.
Note: Not applicable on manual transmission vehicles.
• Connect the Light Green wire to the parking brake wire.
• Connect the ODBII harness with stripped leads, to the 2-pin harness.
• Run the wires from ODBII harness with stripped leads to the ODBII connector in
the vehicle, and then connect them as shown .
OBDII CONNECTOR FACE VIEW
PINK WIRE
1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16
PINK/BLUE WIRE