Axxess Interface Installation; Tools Required; Connections To Be Made - Metra 99-6526 Instrucciones De Instalación

Axxess Interface Installation

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Retains the factory personalization menu and climate controls status
• Can be used in amplified or non-amplified models
• Provides NAV outputs (parking brake, reverse, and speed sense)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• High level speaker input
• Retains balance and fade
• Ability to add aftermarket backup camera and additional video input
• Retains factory screen
• Micro "B" USB updatable
ATTENTION: The rear-view camera Input is used to display the climate control
status and personalization menu. If the aftermarket radio does not have a screen
with a rear-view camera Input, then there will be no visualization of the climate
controls status and personalization menu, which makes adjusting the climate control
impossible. An externally mounted screen could be substituted in this situation.
INTERFACE COMPONENTS
• Axxess Interface • 18-pin harness with stripped leads
• 6526 harness • 4-pin harness with stripped leads

TOOLS REQUIRED

• Cutting tool • Crimping tool • Tape
• Connectors (example: butt-connectors, bell caps, etc.)
99-6526

Connections to be made

From the 18-pin harness with stripped leads to the aftermarket radio:
• Connect the (2) Red wires to the accessory wire.
• Connect the Orange wire to both the illumination wire, AND the Orange wire
on the 4-pin connector. (If the aftermarket radio has no illumination wire, just
connect the (2) Orange wires together.)
• Connect the Blue/White wire to the amp turn on wire. (This wire must be
connected to hear sound from the factory amplifier, if applicable.)
• Connect the White wire to the left front positive speaker output.
• Connect the White/Black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/Black wire to the right front negative speaker output.
• Tape off and disregard the Brown, Green, Green/Black, Purple,
and Purple/Black wires, they will not be used in this application.
Continued on the next page
6