Connections - Metra 99-5853CH Instrucciones De Instalación

From the 16-pin harness to the aftermarket radio, connect the:
• Red wire to the accessory wire.
• Blue/White wire to the amp turn on wire, if the vehicle is equipped with a Shaker/Shaker-Pro
sound system.
• Orange/White to the illumination wire (if applicable).
• Gray wire to the right front positive speaker output.
• Gray/Black wire to the right front negative speaker output.
• White wire to the left front positive speaker output.
• White/Black wire to the left front negative speaker output.
The following (3) wires are only for multimedia/navigation radios that require these wires.
• Blue/Pink wire to the VSS/speed sense wire.
• Green/Purple wire to the reverse wire.
• Light Green wire to the parking brake wire
• Tape off and disregard the following (5) wires, they will not be used in this application:
Brown, Green, Green/Black, Purple, Purple/Black
6

CONNECTIONS

From the 5853 harness to the aftermarket radio, connect the:
• Black wire to the ground wire.
• Yellow wire to the battery wire.
• Green wire to the left rear positive speaker output.
• Green/Black wire to the left rear negative speaker output.
• Purple wire to the right rear positive speaker output.
• Purple/Black wire to the right rear negative output.
• Disregard the Red and White RCA jacks labeled "RSE/SYNC®/SAT", they will not be used in
this application.
• Disregard the Red and White RCA jacks labeled "FROM 3.5", they will not be used in this
application.
• Tape off and disregard the following (3) wires, they will not be used in this application:
Blue, Blue/White, Red.
• Disregard the DIN jack, it will not be used in this application.
Continued on the next page
|
386.257.1187 MetraOnline.com