TomTom Rider Manual Del Usuario página 6

Using your TomTom Rider
Using a headset
We recommend using a compatible headset with
your TomTom Rider to hear spoken instructions,
make and receive hands-free phonecalls and hear
warning sounds on your Rider. This makes riding
with your Rider as safe as possible. TomTom rec-
ommends the Cardo scala-rider™ Bluetooth® head-
set. For more information and a full list of
compatible headsets, go to tomtom.com/rider-
headsets.
The Cardo scala-rider™ Bluetooth® headset is
included in some products. The instructions below
describe how to set up this headset.
To turn the headset on, press and hold the on/off
button for 10 seconds, until the LED flashes blue 3
times. An ascending alert tone is played. When the
headset is on, the LED flashes blue every 3 seconds.
To turn the headset off, press and hold the on/off
button for 3 seconds, until the LED flashes red 3
times. A descending alert tone is played.
If you did not establish a Bluetooth connection
between your Bluetooth headset and your
TomTom Rider when you first turned your Rider on,
you can establish the connection at any time.
From the Main Menu, tap options. Tap Connect to
headset and follow the instructions to establish the
connection.
Attach your headset to your helmet as shown at the
start of this guide. Make sure you position the
microphone correctly. For best results, don't posi-
tion the microphone directly in front of your mouth,
position it just to the side of your mouth.
Cardo scala-rider™ headset
A
B
C
A Microphone
B On/off button
C Speakers
D LED
E Volume down
F Volume up
G Charging connector
Before you can use your Bluetooth headset, fully
charge the headset using the charger supplied with
the headset.
To fully charge the headset takes between 2 and 3
hours. When charging, the LED is a steady red.
When charging is finished, the LED turns off.
When the batteries are running low, an alert tone is
played.
8
D
E
F
G