Dell PowerEdge 2800 Actualización De Información página 8

Table 1-1. Effect of BMC Use of NIC1 on Teaming Functionality (continued)
Action
NIC1 BMC access disabled
after team is created
NOTE:
To avoid false error messages, use only the Intel
Changing the LCD Display of the System ID and Name
To change the LCD display of the system ID and name, enter the System Setup program as
described in the User's Guide and select Embedded Server Management from the main setup
screen. Then, in the screen that opens, select User-Defined, and under User Defined LCD String:
enter the desired system ID for Line 1 and system name for Line 2.
LCD Status Messages Update
Table 1-2 lists updates to the LCD status messages that can occur, and the probable cause
for each message. The LCD messages refer to events recorded in the system event log (SEL).
For information on the SEL and configuring system management settings, see the systems
management software documentation.
Table 1-2. LCD Status Messages
Line 1 Line 2
Message Message
SYSTEM SYSTEM NAME
ID
6
Information Update
AFT, ALB/RLB, and SFT
Teaming Mode
Effect
Normal teaming functionality
®
Causes
SYSTEM ID is a unique name,
five characters or less, defined
by the user.
SYSTEM NAME is a unique
name, 16 characters or less,
defined by the user.
The system ID and name display
under the following conditions:
• The system is powered on.
• The power is off and active
POST errors are displayed.
IEEE 802.3ad and Ether Channel
Teaming Mode
Effect
Normal teaming functionality
NIC drivers provided by Dell.
Corrective Actions
This message is for information
only.
You can change the system ID
and name in the System Setup
program. See your User's Guide
for instructions.