Adjusting The Brightness; Setting The Rear Output And Subwoofer Controller; Switching The Telephone Muting/Attenuation - Pioneer DEH-P7750MP Manual De Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Section
11
Initial Settings

Adjusting the brightness

You can adjust the display brightness. Initially
this mode is set to 12.
1
Use Multi-Control to select Brightness.
Brightness appears in the display.
2
Push Multi-Control left or right to ad-
just the brightness level.
Each pushing Multi-Control left or right in-
creases or decreases the brightness level. 0 
15 is displayed as the level is increased or
decreased.
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (Rear SP :FULL) or subwoofer
(Rear SP :S/W) connection. If you switch the
rear output setting to the Rear SP :S/W, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (Rear SP :FULL). When rear out-
put is connected to full range speakers (when
Rear SP :FULL is selected), you can connect
the RCA subwoofer output to a subwoofer. In
this case, you can select whether to use the
subwoofer controllers (low pass filter, phase)
built-in Preout :S/W or the auxiliary
Preout :FULL.
1
Use Multi-Control to select SW control.
SW control appears in the display.
2
Press Multi-Control to switch the rear
output setting.
Pressing Multi-Control will switch between
Rear SP :FULL (full-range speaker) and
50
En
Rear SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select Rear SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer Rear SP :S/W.
# When the rear output setting is Rear SP :S/W,
you cannot change the subwoofer controller.
3
Push Multi-Control left or right to
switch the subwoofer output or nonfading
output (full-range RCA output).
Each pushing Multi-Control left or right will
switch between Preout :S/W and
Preout :FULL and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 46)
or subwoofer output (refer to Using subwoofer
output on page 45) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
! Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is turned off or attenuated,
MUTE or ATT is displayed and no audio ad-
justment is possible.
! Sound from this system returns to normal
when the muting or attenuation is can-
celled.

Publicidad

Tabla de contenido
loading

Tabla de contenido