Remedy Of Faults - Oase Water Starlet Instrucciones De Uso

Start-up
Switching on the unit: Plug the power plug of the transformer into the socket. The unit switches on immediately.
Switching off the unit: Disconnect the transformer power plug.
Attention! Never operate the unit without water or without a pump filter!
Note!
The water feature patterns of the Water Starlet are default programmed. The program cannot be altered.
Maintenance and cleaning
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
− Prior to reaching into the water, disconnect the power supply to all units used in the water.
− Disconnect the power plug prior to carrying out work on the unit.
Cleaning the unit (F-I)
− For opening, undo the four screws (10) at the underside of the unit and lift off the strainer casing (11).
− Pull the individual pump (12) upward and off.
− Pull off the pump lid (13) sideways and pull out the impeller (14).
− Clean all parts under running water.
− For cleaning the nozzle, remove the nozzle holder (15) from the lid with a slight twist.
Reassembling the unit
Reassemble the unit in the reverse order (F-I).
− Turn the nozzle holder (15) into the lid and plug the pump (12) onto the nozzle.
Note: When inserting the nozzle holders (15) and pumps (12), note the correct order of the numbering (16) in the lid. A
different order will result in a changed water feature and light pattern.
− Ensure the correct seating of the pumps (12), otherwise the strainer casing (11) cannot be closed.
− Lay the cables (17) such that they cannot be crushed. Route the connection cable (18) through the cable lead-
through (19) in the lid.
Storage/Over-wintering
Remove the unit at temperatures below zero degrees centigrade. Thoroughly clean and check the unit for damage.
Store the unit immersed in water or filled with water in a frost-free place. Do not flood the power plug!
Repair
In the event of damage to the cables or the housing, the transformer cannot be repaired and, therefore, has to be
replaced.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.

Remedy of faults

Malfunction
Pump does not switch on
Insufficient fountain height
The unit floats up
Cause
No mains voltage
Impeller blocked or soiled
Nozzles soiled
Strainer casing soiled
Remedy
Check mains voltage
Check supply lines
Clean impeller
Clean nozzles
Clean strainer casing
- GB -
9