Kohler K-2298 Guía De Instalación Y Cuidado página 6

Installation
1
Drill a pilot hole.
Percer un trou pilote.
Taladre un orificio guía.
3
Drop-In Installation
Drill a pilot hole on the inside of the traced pencil line.
Cut out the countertop opening by carefully following the pencil line.
Position the bathroom sink in the countertop cutout. Verify fit and clearance.
Remove the sink.
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation instructions.
Clean the countertop and the underside of the sink rim.
Position the sink in the countertop cutout.
Apply a continuous bead of silicone sealant around the edge of the sink.
Immediately wipe away excess sealant and fill voids as needed. Allow the sealant
to set for 30 minutes before proceeding.
Complete the faucet and drain installations.
Run water into the bathroom sink and check for leaks.
Installation
Installation à encastrer par le dessus
Percer un orifice pilote sur l'intérieur de la ligne tracée au crayon.
1201382-2-A
2
Cut along the pencil line.
Découper le long de la ligne
au crayon.
Corte a lo largo de la línea
de lápiz.
4
Silicone Sealant
Joint en silicone
Sellador de silicona
6 Kohler Co.