Assembly Or Installation Instructions; Important - Harbor Breeze 00856 Guia De Inicio Rapido

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
1. Attach mounting plate (A) to outlet box (not
included) using two screws (not included).
Securely tighten two outlet box screws. Pull
black, white, and grounded wires out of outlet
box and through the hole in the mounting plate
(A).
2. Place trim ring (C) over canopy, and lay it on fan
motor (B).
3. Loosen two preassembled screws across from
each other on the mounting plate (A). Remove
and save remaining two preassembled screws.
Hang fan motor (B) on mounting plate (A)
hook using one of the non-slotted holes in the
canopy.
IMPORTANT: Do NOT use this fan with a dimmer
switch or variable speed wall control. Using a dimmer
switch or variable speed wall control will damage the
fan.
ON
ON / OFF
NO Variable
NO Dimmer
switch
speed wall
switch
control
1
Outlet box
A
Screw
2
Canopy
B
3
Screw
Hook
Canopy
B
Lowes.com/harborbreeze
6
ASSEMBLY INSTRUCTIONS
4. Connect the BLACK wire from the fan to the
BLACK wire from the ceiling.
Connect the WHITE wire from the fan, to the
WHITE wire from the ceiling.
Connect all GROUND (GREEN) wires from the
fan together to the GREEN/BARE wire from
ceiling.
Connecting the GREEN/GROUND wires is
conducive to receive the signal of the remote
control.
Note: The BLACK wire is the hot power for the
fan and light kit. The WHITE wire is common for
fan and light kit. GREEN wire is the ground wire.
lf the household wires are different colors than
referred to above, stop immediately and consult a
professional electrician to determine proper wiring.
C
5. Twist wire ends together and screw wire
connectors (AA) on in a clockwise direction.
Tape wire connectors (AA) and wires together
with electrical tape (not included).
Hardware Used
AA
Wire Connector
6. Align keyhole slots on the fan motor (B) with the
protruding screw heads on the mounting plate
(A). Lift the fan motor (B) up to the mounting
plate (A), making sure not to break any wire
A
connections. Rotate the fan motor (B) clockwise
until the screw heads fully engage into keyhole
slots. Insert the previously removed screws
(Step 3, page 6) and securely tighten all the
screws.
B
4
Ground/
Supply circuit
Green
White
Black
5
x 4
AA
6
A
Lowes.com/harborbreeze
7
outlet box
Outlet box
G
GREEN/
e r
e
/ n
Ground
GROUNDED
receiver
Receiver
Screw
B

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

0085706937260693727

Tabla de contenido