Standard Or Angle Mounting Instructions - Harbor Breeze 40075 Manual De Instrucciones

STANDARD OR ANGLE MOUNTING INSTRUCTIONS

1. Remove the downrod pin (DD) and downrod clip
(EE) from the downrod (A). Then partially loosen the
motor-housing set screws (HH) in the yoke at the top
of the motor housing (E).
Helpful Hintt Downrod style mounting is best suited
for ceilings 8 ft. (2.44 m) high or higher. For taller
ceilings you may want to use a longer downrod
(not included) than the one provided. Angle style
mounting is best suited for angled or vaulted ceilings.
A longer downrod is sometimes necessary to ensure
proper blade clearance.
Hardware Used
DD Downrod Pin
EE
Downrod Clip
Motor Housing
HH
Set Screw
2. Insert the downrod (A) through the canopy (B),
canopy cover (J), and yoke cover (D). Ensure that
the canopy cover (J) is turned with the shiny side
toward the motor housing (E). Thread the wires from
the motor housing (E) up through the downrod (A).
1
EE
x 1
x 1
x 2
2
A
9
A
DD
A
J
D
Lowes.com/harborbreeze
HH
E
B
E