Install The Door/Window Contact; Test And Install The Pir Motion Detector; Overview - Smanos X500 Manual Del Usuario

Install the door/window contact

Make sure the contact works properly before installing it. There are triangle marks on
the side of the transmitter and magnet. Make sure the triangle marks is close to each
other and within the range of 1 cm. As long as the space between the transmitter and
magnet is over 2 cm and the LED on the transmitter is on.
Secure the contact with double-sided tapes
Secure the transmitter and magnet on the desired locations with double-sided tapes.
43
X500-UM-EN-IT-ES-PT-V1.0.indd 50-51
Note: If this product is installed on metal door, place
spacers under the transmitter and magnet.
This product is not suitable for shutter door, please
purchase shutter door sensor for your use.

Test and Install the PIR Motion Detector

The detector adopts digital dual-core fuzzy logic control processing technology and
intelligent analysis algorithm, effective resolution of interfering signal and human
movement signal, preventing false alarm. It features automatic temperature
compensation and resistance to flow technology, adapting to environmental and
temperature change. It can detect human movement within the 8-meter cone space,
suitable for halls, hallways, etc.

Overview

Detection
Lens
LED Indicator
LED indication
Flash continuously: Self-testing.
Flash once: Intrusion is detected.
Flash twice: 3 minutes testing mode is finished, enters power saving mode.
Flash once per 3 seconds: Low battery indication, user will receive SMS notification if
detector was connected with panel, please change the batteries immediately.
PCB layout
Tamper Switch
Note: When tamper switch is triggered, system will enter alarm state.
EN
Test Button
Double-sided
Tape Stick Place
Bracket Slot
Infrared Sensor
LED Indicator
44
2016/12/9 9:27:55