Getting Started; Inserting Sim Card; Turning On The Control Panel; Network Connection (Indicator) - Smanos X500 Manual Del Usuario

Getting Started

Inserting SIM card

Before inserting the SIM card, please perform the following steps:
Make sure the alarm system is powered off.
1.
IMPORTANT: remove the (default) code permanently from the SIM card.
2.
Turn off the voice mail function if it is enabled.
3.
Insert the SIM card into the SIM card slot from the alarm system as shown in the
4.
illustration below.
OFF ON
SPK
Wired connection (Siren 12V≤500mA)
GND
Output for electronic lock
PUSH
GND
Wired sensor (Normal zone)
ZONE 1
Wired sensor (24-H zone)
24H ZONE
IMPORTANT: In order to use and set up the alarm system, SMS texting
will be used. The use of SMS texting cost money. Consult your carrier for
the costs.
IMPORTANT: The Android and/or Apple App both make use of SMS texting.
7
X500-UM-EN-IT-ES-PT-V1.0.indd 14-15

Turning on the control panel

Connect the power adapter to the connector in the back of the control panel. Then
slide the power switch to "On".

Network connection (indicator)

After switching on the system, the network icon
indicates that the control panel is connected to a network.

Settings inquiry by SMS

IMPORTANT: If the network icon does not shown on the LCD screen, the control
panel has not connected to a network. Make sure the security code of the SIM
card is permanently deactivated.
The settings of the alarm system can be changed by simply sending a SMS with a
mobile phone. You can request an entire menu for information on possible SMS
commands. The complete menu consists of three parts which can be requested by
sending one, two or three question marks as can be seen below.
Sending " ? "
Control panel replies:
'0' Disarm
'1' Arm
'2' Home mode
'3' Two-way talk
'4' Call-back voice memo
'00' Settings inquiry
'??' Store phone and SMS No.
[ ] will show on the LCD screen. This
?
8
2016/12/9 9:27:50
EN